 In this 5 min video I demonstrate a simple and fast way to recess a part of a surface. This can be done on a closed polysurface or any open surface. Very handy trick! NOTE: My video capture software did not capture the pop-up dialog boxes in this video, refer to the picture above to see what the BlendSrf dialog box looks like.
0 Comments
Leave a Reply. |
If you find any of these videos helpful, perhaps you'd like to buy me a coffee! If so, just click the the following link or scan the QR code.
And THANK YOU!!
Author“Gary Dawson is owner of Gary Dawson Designs, an online custom design operation that was once featured as a “Best of the Best” by Instore Magazine. Dawson has over 40 years experience in creating designs that capture the personalities and stories of his customers. He is a frequent contributor to MJSA Journal, a founding member of the Council of Custom Jewelers, and a designated “Mentor Jeweler”. He has delivered seminars and presentations at numerous events, including AGTA GemFair, Portland Jewelry Symposium, and the Santa Fe Symposium on Jewelry Manufacturing Technology.” ~Jewellery Business Magazine 
Archives
March 2024
Categories |
RSS Feed